歡迎光臨億煤機械裝備制造有限公司!
商標注冊證:構得

如電話無法接通,請撥打集團 銷售專員熱線

銷售熱線:
400-086-0537

億煤機械乳化液泵站

乳化液泵站

乳化液泵站主要用作煤礦井下機械化采煤推移運輸機的動力源,也適用于地面清洗設備清洗設備以及液壓設備作動力源,工作液為3-5%乳化液或清水。

乳化液泵站組成

  • 乳化液泵

  • 乳化液箱

  • 液壓系統
    控制臺

  • 電子保護
    監控系統

乳化液泵站尺寸

乳化液泵站尺寸

因產品生產批次、具體型號不同,以上圖片僅供參考,詳情可聯系我們的銷售人員進行具體核實!

乳化液泵站參數

BRW40/20型乳化液泵站型號參數

進水壓力
常壓
公稱壓力
20MPa
公稱流量
40L/min
曲軸轉速
547r/min
柱塞直徑
50mm
柱塞行程
50mm
電機轉速
1470r/min
電機功率
15KW
外形尺寸
泵,664*600*335mm 總成:1380*664*665mm
BRW40/20型乳化液泵站型號參數
BRW40/20 型號
B-------------------------泵
R-------------------------乳化液
W------------------------臥式
40------------------------公稱流量
20------------------------公稱壓力

乳化液泵站結構特點

臥式三柱塞
錐形吸、排液閥
四極防爆
電機驅動
輪胎式聯軸器
一級圓柱齒輪減速
設安全閥
無卸載閥
電機與泵安全
在同一底拖上

乳化液泵站適用范圍

乳化液泵站應用于各種礦山、國防、隧道及坑道作業中。主要是為采煤工作面、掘進機提供高壓乳化液,可滿足普采工作面、綜采工作面的不同要求。自動進水、泵超壓自動卸荷、乳化液配比濃度可自由 調節,具有操作靈活、移動方便、高效、節能、安全、耐腐蝕、抗磨損、傳輸距離遠等特點。

Emulsion pump station used in the operation of various mines, national defense, tunnel and tunnel. Mainly for the coal face, tunneling machine with high pressure emulsion, can meet the general mining face, fully mechanized face different requirements. Automatic water inlet, pump overpressure automatic unloading, emulsion concentration ratio can be adjusted freely, has the advantages of flexible operation, convenient movement, efficient, energy-saving, safety, corrosion resistance, wear resistance, transmission distance and so.

泵站操作的運行與調試

泵啟動前,首先應仔細檢查潤滑油的油位是否符合規定,油位不應低于油標線。檢查各部位元部件有無順壞,各緊固件,特別是滑塊鎖緊螺母不應松動。各連接管道是否有滲透現象,吸、 排液軟管是否折疊與死彎。

Pump before the start, should first carefully check the oil level is in conformity with the provisions, the oil level should not be less than the oil line. Check all parts components without break, fasteners, especially the slide lock nut should not loose. The connecting pipe is penetration, suction, discharge hose is folding and bending die.

在確認無故障后,打開箱組的手動卸載閥開關,將吸液腔的放氣堵擰松,把吸液腔空氣放盡,出液后擰緊。點動電動機的開關,看電動機的旋轉箭頭方向是否正確。

No confirmation of fault, manual unloading valve switch box group, will air suction cavity plugging loosen, the suction chamber of the air discharge, liquid after tightening. To move the motor switch, rotate the arrow direction of motor is correct.

泵啟動后,應密切注意它的運行情況,空載運轉5~10min泵,泵應沒有異常噪音、抖動、管道泄露等現象,檢查泵頭螺堵,泵與箱體聯螺釘應無松動現象,關閉液箱的手動卸載閥開關,方 可投入正常運行。

The pump is started, should pay close attention to the running state, no-load running 5 ~ 10min pump, pump should be no abnormal noise, jitter, pipeline leakage phenomenon, check the pump head screw plug, pump and tank coupling screws should be no loose, manual unloading valve switch off the tank, can be put into normal operation.

泵投入運行后,要注意箱體溫度不宜過高,油溫應低于85°C,注意油位的變化不低于標線以下,液溫不超過40°C.

Pump after the operation, should pay attention to the temperature is not too high, the oil temperature should be lower than 85 ° C, notice the oil change is not lower than the line below, liquid temperature not exceeding 40 ° C.

在泵運行中要注意栓塞密封是否正常。

In the pump is running to the attention of embolism seal is normal.

泵站在運行中,公稱流量下,壓力從空載逐漸加載到所 需壓力。公稱壓力下,泵站各部位不得有松動、滲透液現象。

Pumping station in operation, the nominal flow, pressure from no-load gradually loading to the required pressure. Nominal pressure, parts of the station may have loose, permeate the phenomenon.

乳化液泵站BRW40/20相關產品

產品分類

關于我們
公司簡介
榮譽資質
產品中心
運轉設備
提升設備
大型設備
鑿巖設備
支護設備
噴漿設備
防爆電器
鐵路物資
新聞中心
公司新聞
業內資訊
人才戰略
誠聘英才
人才理念
投遞簡歷
客戶服務
客戶服務
銷售網絡
售后服務
聯系我們
聯系我們
榮譽資質
公司地址:中國·山東省濟寧市高新區開源路北11號   銷售熱線1:18553715771   銷售熱線2:18553713830   銷售熱線3:15376502832  電子郵件:yimeijixie@163.com
Copyright ? 1994-2017 億煤機械裝備制造有限公司 All rights reserved 魯ICP備12023056號-1 責任編輯:姜圣凱|編輯:袁方
營業執照公示 中國警察網 ICP經營許可證 網警備案 信用評級AAA 可信網站 中國互聯網協會
偷自视频区_皇色 网站大全_A级毛片高清免费视频就